Faqs Categories: Any-Grid Hybrid Inverter Charger Series (PSW-H)
August 9, 2021
After installation of an Any-Grid PSW-H inverter, does the filter need attention? If so, what should be done?
Cleaning dust filters and removing undergrowth dust at the vents that can impede airflow, is something to monitor over time. Simple regular cleaning can help an inverter perform at optimum efficiency to avoid any level of overheating. Overheating results in an unnecessary waste of energy. Every Watt counts, so it
July 8, 2021
What is the largest and smallest battery bank one can use with Any-Grid PSW-H Inverters?
When it comes to pairing battery banks with your Any-Grid PSW-H inverter, the main thing you need to consider is nominal voltage. That is, if you have a 24 Vdc inverter, make sure that you have a 24 Vdc battery bank. In terms of bank size, theoretically there is no
July 8, 2021
What is the idle power consumption of the Any-Grid PSW-H inverter?
In idle mode, if the AC output switch is activated, but no consumers are connected, the internal consumption is <60W. However, if the AC output switch is deactivated, which means that the inverter is inactive, the internal consumption is <15W.
July 8, 2021
Does the Any-Grid PSW-H inverter pass AC input through to the AC output, thus retaining phase information?
Yes, since the Any-Grid PSW-H does not rectify everything to a DC bus (as that would incur high efficiency losses). This means that if you have multiple units in parallel on one phase and multiple units on another phase, they cannot have differing AC input sources. For example, one phase
July 8, 2021
Is it possible to combine a 3 kW and 5 kW inverter to achieve an 8-kW inverter array or does the 3 kW only support 24V DC inputs, thus making them “unstackable”?
If you plan to wire more than one unit in parallel, they all need to be the same model number. Up to 9 units may be wired in parallel on a single phase and they must ALL be connected to the same battery bank if a battery bank is used.